Audio Booster

The amplifier's gain is nominally 20 dB. Its frequency response is determined primarily by the value of just a few components-primarily C1 and R1. The values of the schematic diagram provide a response of ±3.0 dB from about 120 Hz to better than 20,000 Hz.Actually, the frequency response is ruler flat from about 170 Hz to well over 20,000 Hz; it's the low end that deviates from a flat frequency response. The low end's roll-off is primarily a function of capacitor C1(since RI's resistive value is fixed). If C1's value is changed to 0.1 pF, the low end's comer frequency-the frequency at which the low-end roll-off starts-is reduced to about 70 Hz. If you need an even deeper low-end roll-off, change C1 to a 1.0 pF capacitor; if it's an electrolytic type, make certain that it's installed into the circuit with the correct polarity, with the positive terminal connected to Q1's base terminal.

Parts:

P1 = 100K

R1 = 47K

R2 = 470K

R3 = 10K

R4 = 560R

R5 = 270R

C1 = 0.1uF-25v

C2 = 3.3uF-25v

C3 = 470uF-25V

D1 = 5mm. Red Led

B1 = 9v Battery

J1 = RCA Audio Input Socket

J2 = RCA Audio Output Socket

S1 = On-Off Switch